Vizio L42HDTV10A User Manual download pdf (Page 58)

CONFIDENTIAL – DO NOT COPY

Page 7-39

File No. SG-0198

BUS OPERATION--2

Notes:

1.Code=00h means unprotected, or code=01h protected.

2.Code=99 means factory locked, or code=19h not factory locked.

WRITE COMMANDS/COMMAND SEQUENCES

To program data to the device or erase sectors of memory , the system must drive WE and CE to

VIL, and OE to VIH.An erase operation can erase one sector, multiple sectors , or the entire device.

A "sector address" consists of the address bits required to uniquely select a sector. Writing specific

address and data commands or sequences into the command register initiates device operations.

Table A defines the valid register command sequences. Writing incorrect address and data values or

writing them in the improper sequence resets the device to reading array data. Section has details

on erasing a sector or the entire chip, or suspending/resuming the erase operation.

After the system writes the Automatic Select command sequence, the device enters the Automatic

Select mode. The system can then read Automatic Select codes from the internal register (which is

separate from the memory array) on Q7-Q0. Standard read cycle timings apply in this mode. Refer

to the Automatic Select Mode and Automatic Select Command Sequence section for more

information.ICC2 in the DC Characteristics table represents the active current specification for the

write mode. The "AC Characteristics" section contains timing specification table and timing diagrams

for write operations.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 106 107

No comments

Vizio L42HDTV10A User Manual Page 58